Focal Sib Evo User Manual page 14

Sib Evo - Sib Evo Dolby AtmoS®
User Manual
D - Wall-mounting
1- Remove the base from the loudspeaker by unscrewing the screw underneath the base.
Caution: keep the screw to one side as it will be used again in step 3 (fig. D1).
2- Route the cable through the intended opening on the wall-mount and fix to the wall using the 3
screws supplied (fig. D2).
3- Position the loudspeakers on the wall-mount and secure in place using the screw put to the side in
step 1 (figs. D2, D3).
4- Connect the cables (see E – Connections).
5- Incline the loudspeaker according to your installation and secure in place by tightening the screw
underneath the ball joint using the Allen key supplied (fig. D5).
E – Connections
Connect your Sib loudspeakers to the amplifier using a hi-fi quality cable with a cross-section area of
between 0.75mm² and 2mm² and with the polarity marked on one of the conductors.
Respect the polarity making sure to connect the "+" terminal on the amplifier to the "+" terminal on
the corresponding loudspeaker.
Repeat the operation for the "-" terminals (fig. E1).
For the Sib Evo Dolby Atmos® satellite speakers, respect the conductors indicated on the back of
the satellites, the forward firing speaker driver corresponds to the bottom connectors, and the Dolby
Atmos® upward-firing speaker driver corresponds to the top connectors (figs. E2, E3).
14