Scan Button - Sharper Image OWN ZONE Instruction Manual

VOLUME CONTROL
(RIGHT EAR)
SCAN
BUTTON
PAIRING YOUR OWN ZONE™ WIRELESS HEADPHONES
Your headphones should pair automatically. If they do not pair automatically:
1. Push and hold the power button on top of the transmitter until the LED indicator
turns BLUE.
2. Push and hold the power button on the right earcup on the headphones until the
LED indicator slowly flashes BLUE.
3. Press and hold the SCAN button on the side of the transmitter, while holding the
SCAN button on the headphones you want to pair. The LEDs will rapidly flash
BLUE while pairing and will turn solid when paired.
NOTE: You may pair additional sets of Own Zone™ Wireless Headphones to the
transmitter by following steps 2 and 3. Other models of wireless headphones are
not compatible with this transmitter.
POWER BUTTON
(LEFT EAR)
LED

SCAN BUTTON

LED
TRANSMITTER
8
MICRO USB
CHARGING PORT
(RIGHT EAR)
CHARGING YOUR OWN ZONE™ WIRELESS HEADPHONES
For best results, make sure to fully charge the headphones before first use.
1. Plug the small end of the micro USB cable (included) into the micro USB port on
the headphones.
2. Connect the large end of the cable to a USB power source (ie. computer,
phone charger, 5V USB Adapter). You'll know your headphones are charging
because the LED indicator will power on. When headphones are fully charged,
LED will turn OFF.
NOTE: If you hear a series of beeps during use, that means your batteries are low and
your headphones need to be charged.
POWER BUTTON
(LEFT EAR)
LED
5