Advertisement
Quick Links
INSTRUCTION MANUAL
FCC COMPLIANCE
FOR TIPS AND INSTRUCTIONAL VIDEOS, PLEASE VISIT
WWW.OWNZONETIPS.COM
FCC PART 15:
This equipment has been tested and found to comply with the requirements for a
Class B digital device under Part 15 of the Federal Communications Commission
(FCC) rules. These requirements are intended to provide reasonable protection
OWN ZONE™ WIRELESS HEADPHONES
against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Re-orient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
TRANSMITTER (1)
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Do not attempt to repair or modify this equipment.
WARNING: Changes or modifications to this equipment not expressly approved by
the party responsible for compliance could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
MICRO USB CHARGING CABLES (2)
following two conditions:
1. This device may not cause harmful interference, and
OWN ZONE™ WIRELESS HEADPHONES (1)
2. This device must accept any interference received, including interference that may
cause undesired operation.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC's
RF exposure guidelines, place the product at least 20cm from nearby persons.
OPTICAL CABLE (1)
RCA CABLE (1)
AUX CABLE (1)
FOR TIPS AND INSTRUCTIONAL VIDEOS, PLEASE VISIT
WWW.OWNZONETIPS.COM
© 2018 APG. All rights reserved. Own Zone is a trademark of APG. Made in China.
IM3
Advertisement
Summary of Contents for Sharper Image OWN ZONE
- Page 1 RF exposure guidelines, place the product at least 20cm from nearby persons. OPTICAL CABLE (1) RCA CABLE (1) AUX CABLE (1) FOR TIPS AND INSTRUCTIONAL VIDEOS, PLEASE VISIT WWW.OWNZONETIPS.COM © 2018 APG. All rights reserved. Own Zone is a trademark of APG. Made in China.
- Page 2 INPUT 2 INPUT 1 STEP 2: Connecting to your TV’s audio port Own Zone™ Wireless Headphones can be connected to the TV three different ways. Choose the one which works best for your TV. 1. The Preferred Method: Optical This method allows sound to be heard through the headphones and the TV. If you want sound to only come through the headphones, mute the TV.
-
Page 3: Troubleshooting
I followed these steps, but I still don’t hear anything from my headphones. AUDIO AUDIO • If you have a second TV at home, set up the Own Zone™ Wireless Headphones on AUDIO that TV and see if the audio works. If it works on the second TV, you may need to... - Page 4 In the rare event of a malfunction, you may need to perform a system reset. In the If they do not, see the PAIRING YOUR OWN ZONE™ HEADPHONES (page 8) section event that a reset is needed, follow these steps: in this manual.
-
Page 5: Scan Button
LED indicator will power on. When headphones are fully charged, LED will turn OFF. NOTE: You may pair additional sets of Own Zone™ Wireless Headphones to the transmitter by following steps 2 and 3. Other models of wireless headphones are NOTE: If you hear a series of beeps during use, that means your batteries are low and not compatible with this transmitter. - Page 6 PAIRING BUTTON USING THE HEADPHONES AS WIRED HEADPHONES If you do not wish to use the wireless transmitter, you may use Own Zone™ Wireless Headphones as wired headphones. To do so, follow these steps: ADJUSTING THE VOLUME ON YOUR HEADPHONES 1.