Table of Contents
Advertisement
How to Install the Wall Mount Bracket
3
Tighten the screws of the plastic hanger (shown
in picture 2) to the back side of the PDP
Monitor.
How to Adjust Mounting Angle
➢
Please secure the mounting bracket on the wall surface after setting its angle at 0°
1
Secure the SET to the wall mount bracket.(Please refer to the
follow ing instructions.)
2
Set the angle by pulling the upper end of the SET attached to
bracket in the direction of the arrow. (Refer to the illustration
on the right.)
3
The angle can be adjusted from 0° to 15° by ±2°.
Connecting External Devices to the PDP Monitor
➢
To connect external devices such as a DVD or a Home Theater System to the PDP Monitor, please refer to
following instructions:
4
Remove the Safety Pins. Fasten the 4 plastic
latches assembled at step (#) on the back side of
the PDP Monitor using the guide holes of the wall
mount, push (!) and hook (@) down to secure the
PDP Monitor on the wall mount as illustrated.
Secure the PDP Monitor by inserting the Safety
Pins, not to fall from the wall mount.
PDP Monitor panel
Wall attachment
panel bracket
1
Be sure to remove the safety pins underneath the PDP
Monitor.
➢
If the safety pins are not removed, the angle cannot be
adjusted. Any attempt to do so may cause damage to
the PDP Monitor.
2
Hold onto the bottom of the PDP Monitor and pull forward
fully as directed by the arrow as illustrated) to adjust the
angle. (0°~20° by 2°) Insert the Safety Pins to the front
guide holes on both sides as illustrated in figure @.
➢
Viewing the PDP Monitor after connecting the external
devices Remove the Safety Pins to adjust the angle to
0°, and then secure the Safety Pins again.
☛
For safety, be sure to secure the PDP Monitor using
the safety pins. If the safety pins are not used, the
PDP Monitor may fall, causing serious injury.
English - 19
Wall
Hold onto the middle of the PDP
Monitor to adjust the angle (not the
sides of the PDP Monitor).
Advertisement
Table of Contents
