Intended Use - Separ Filter SWK-2000 Operating Manual

Willibrord Lösing
Filterproduktion GmbH
W. Lösing Filterproduktion GmbH • Am Walzwerk 2 • 45527 Hattingen
The filter may be under pressure. Therefore never open a filter in operation, otherwise fuel may leak
into the environment and the engine draws air, which can cause damage to the engine.
When using duplex or switchable filters, the lever position indicates which filter is in operation. At
this moment the other filter is isolated from the fuel circuit, but still could contain fuel.
Filters with fuel pre heating systems may only be placed in operation when completely filled with
fuel and primed of air.
The electrical current for the heater must never be turned on without grounding and activated
associated control system.
Remove spilled fuel immediately and dispose them in accordance with the applicable statutory
provisions (s. cha. 12).

1.4 Intended use

The filter is intended for the filtration of diesel fuels and mineral oils with a dynamic viscosity < 10
mPas, flash point > 55 °C and boiling point > 160 °C and is designed for operation in between fuel
tank and fuel lift pump (suction side). The filter should never be installed on the pressure side,
behind the fuel pump.
Dok.-Nr.: D10029.EN Rev.: 11 Page 5 of 30
Manual: Water separator / Fuel pre-filter SWK-2000