SpyCameraCCTV SPYBATT007 Product Manual

Product Guide:
SPYBATT007
Get to know your recorder
Note: The large USB port on the left is
non-functioning.
Getting Started
Charging your battery recorder
Before using the SPYBATT007 we recommend
making sure the device is fully charged. To charge,
connect to a PC USB port, or a 5V USB charger.
While charging the blue and red lights will flash,
once fully charged the red light will go out and the
blue light will turn on. The recorder will take 4-6
hours to fully charge from a flat battery.
Installing microSD card
The microSD card is installed in to the bottom
of the unit, and then one of the adhesive plates
are used to cover it. We recommend testing the
device records OK, and that you can access the
recording on your PC before sticking down this
cover.
Playback on your computer
For playing back the files on your computer, we
recommend using VLC Media Player. The latest
version can be downloaded for free from http://
www.videolan.org
Power on – standby mode
Press and hold the power button for 3-4 seconds.
The red status light will come on. The unit is now
in standby mode.
Recording video
From standby mode, click the power button. The
red light will flash twice to indicate the unit has
start to record. To stop recording, click the power
button again. The red light will come on and the
unit is back to standby mode.
Motion detection record
From standby mode, press and hold the power
button for about 3 seconds then release, the
blue light will flash and the red light goes out.
The device is now in motion detection mode.
When motion is detected, the blue light will flash
once to indicate it has started recording. To stop
recording, click the power button and the device
will return to standby mode, indicated by the red
light coming on.