Field Operation - Rankin BF-1000 Owner's/Operator's Manual

4.5

FIELD OPERATION

1. Read Operator's Manual.
2. Lower bucket/forks to the ground, stop
engine, set park brake, remove ignition key
and wait for all moving parts to stop before
servicing, adjusting and repairing.
3. Do not carry people in bucket or on frame.
4. Add weight to rear of frame to balance
bucket load.
5. Stay away from overhead power lines.
Electrocution can occur without direct con-
tact.
Clamp-On Bucket Forks are designed as a light to
moderate duty set of forks that clamps to the front
of the bucket on a loader. The forks are designed
specifically for handling pallets. However the
operator has the responsibility of being familiar
with all operating and safety procedures and
following them.
1. Review and follow the Pre-
Operation Checklist.
2. Attach the forks to the bucket:
a. Position the bucket a few
inches above the ground.
b. Slide one of the forks over
the front of the bucket lip.
14
OPERATING SAFETY
6. Widen wheels or tires to prevent tipping.
7. Use only with a unit with ROPS and a seat
belt.
8. Secure load in bucket to prevent roll-back
down loader arms.
9. Carry load close to the ground when moving.
10. Do not go under raised bucket. Keep others
away.
11. Review safety instructions.
Each operator should review this section of the
manual at the start of the season and as often as
required to be familiar with the machine. When
using, follow this procedure:
Fig. 2 LEFT FORK