Advertisement
Connect the System Cable to the Plasma Display (PDP-501HD).
A
Tighten screws
after connecting
Connectors from Left to Right:
A) to Right Speaker Terminals
(tied black and red cables)
B) to 15pin D-Sub Video 2 Output
C) Ground (GND)
D) to 8pin DIN Control Output
E) to 4pin DIN Video 1 Output
F) to Left Speaker Terminals
(tied black and white cables)
NOTE: DO NOT plug in the Power Cable before all other cables are connected to the units.
Rear side of the Plasma Display (PDP-501HD)
Please refer to the drawing to locate correct terminals.
Page 9
Quick Start Installation Instructions
B
C
D
USE 100VAC ONLY
Remember to connect
E
F
Use separately packaged
step-down transformer to
convert 220-240V to 100V
the GND cable
Advertisement
