Vivitar IPC 117 User Manual page 56

- After about 5 seconds the camera emits 'Reset Success'.
- Very important: Please make sure to continue holding and pressing the button to
progress with the Long Reset that allows you to reset the Wi-Fi.
- After about 30 seconds, the camera emits 'Please use mobile phone for Wi-Fi
configuration. Reset success.'
- Please release the Reset tool.
4. The LED light begins blinking red which indicates the reset is complete and the camera is in
standby mode, ready to be connected. The camera emits again 'Please use mobile phone for
wi-fi configuration.'
5. Please launch the app and select your previously added camera from the IP Cameras
screen.
6. If the app shows that your IP Camera is still offline, please remove your IP Camera and add it
again. Please see the
camera and add it again with the new Wi-Fi.
RECONNECTING: TROUBLESHOOTING
Q: I cannot reconnect to my IP Camera after trying to reconnect as outlined above or
after a factory reset.
A: If you tap on your camera's video thumbnail from the IP Camera screen to reconnect as
described above or if you do a factory reset via the application and there is no connection
with your previously added camera, a window will appear in the app that shows your
'Device is offline'. The following options appear in the window: OK/Cancel and Remove. If
you have checked that your camera is plugged in and powered on, then please proceed
with the steps below to remove your camera and add it again.
REMOVE CAMERA FROM APP
1. Tap Remove from the window option that appears after tapping on the video
thumbnail.
NOTE: You can also remove your IP Camera via the menu that appears below your IP
Camera in the 'IP Cameras' screen. Select 'Remove Device' from this menu or tap the
Troubleshooting section below with details on how to remove the
55