Before installing
Before installing
Drop prevention measure
Take the drop prevention measure by attaching the drop prevention wire to the mounting screw hole.
Mounting the camera to the pan/tilt head
Prepare a commercially available drop prevention wire when mounting this unit to the pan/tilt head.
Mounting the camera to anything other than the pan/tilt head
Prepare the drop prevention wire and camera mounting fixture when attaching to anything other than the
pan/tilt head.
1 Drop prevention wire (optional): 1
Always use the drop prevention wire.
A drop prevention wire is available as an optional accessory. Use with as small slack as allowed by the
installation location or the installation method.
Secure wire diameter of 2 mm or more, length of 300 mm (11 13/16 inches) or less, and strength of the
mounting section of 2000 N or more when using a commercially available drop prevention wire. Also,
separately prepare the mounting screw matching the mounting specification.
Camera side
f Wire length 300 mm (11 13/16 inches): Parts number (DVDW1001ZA)
2 Camera mounting screws (procured locally): 2
Size: 1/4-20 UNC or 3/8-16 UNC
Consider the thickness of the camera mounting fixture for the length.
3 Installation side wire mounting screw (M6 or M4) (procured locally): 1
Use an anchor bolt at the installation location and secure the strength of ten times of the entire weight.
4 Flat washers (procured locally): 2 (for mounting the camera)
For 1/4 inch screw or 3/8 inch screw
5 Spring washers (procured locally): 2 (for mounting the camera)
For 1/4 inch screw or 3/8 inch screw
6 Camera mounting fixture (procured locally): 1
Prepare the fixture with material and shape that can withstand the entire weight of the camera and the
lens.
10
Length of the wire (300 mm) (11 13/16 inches)
6.4 mm
4.5 mm
2 mm
Camera mounting fixture
7–9 mm
6.4 mm
4.5 mm
Installation side
11 mm