Bobrick B-5050 Instruction For Installation And Maintenance

INSTRUCTIONS FOR INSTALLATION AND MAINTENANCE
HOW TO INSTALL THE DISPENSER:
1. Locate soap dispenser so the push button spout will be over the
dispenser and bottom of any shelf, cabinet, or other horizontal
dispenser.
2.
at back of lid. Push key into slot and lift up the back of the lid at the
3.
4.
5.
The surface on which the unit is to be mounted determines the
specific type of mounting required for best installation:
For plaster or dry wall on studs,
codes.
For hollow tile partitions and other instances where applicable, provide
B-5050
0 0260
0
Form No. 5050-69 r1/5/11
Bobrick Model B-5050 Soap Dispenser
© 2011 by Bobrick Washroom Equipment, Inc.
QA010511 Printed in U.S.A.
For brick, concrete, or solid tile walls,
For mirrors or glass surfaces, use the pressure-sensitive tape strips
provided. Do not use the tape for other types of wall surfaces. Clean
any dirt, dust, or oils from the surface and back of vessel. Apply both
tape strips horizontally on the back of the vessel. Press the vessel to
HOW TO REFILL THE SOAP VESSEL:
1.
lift up to remove.
2. Filling soap vessel B-5050: Fill vessel with commercially marketed
all-purpose hand soaps.
3. Insert the tab on the front of lid into the recess inside the front of
lid to secure the latch on the lid into vessel.
MAINTENANCE:
1.
vessel and valve periodically to flush out any contaminates or dried
soap residue. NEVER USE ABRASIVE CLEANERS.
2.
3.
the Allen screw from the bottom of the vessel. Do not disassemble
If for any reason the valve becomes
nonfunctional, a new Valve Assembly replacement kit (Part No.
5050-30) must be ordered. See replacement parts list.
4.
vessel is free from all debris and dried soap. Be sure to remove any
into the bottom screw hole.
REPLACEMENT PARTS LIST
Part Name
Valve Assembly for B-5050
In the U.S.A.: BOBRICK WASHROOM EQUIPMENT, INC.
200 Commerce Drive, Clifton Park, New York 12065-1350
In Canada: BOBRICK WASHROOM EQUIPMENT COMPANY
Part No.
5050-30