Table of Contents
Related Manuals for Dynatech QUASAR
Summary of Contents for Dynatech QUASAR
- Page 1 LIMITADOR DE VELOCIDAD/ OVERSPEED GOVERNOR/ LIMITEUR DE VITESSE/ GESCHWINDIGKEITSBEGRENZER/ QUASAR INSTRUCCIONES DE USO Y MANUTENCIÓN/ INSTRUCTIONS FOR USE AND MAINTENANCE/ INSTRUCTIONS D’USAGE ET ENTRETIEN/ GEBRAUCHS- UND WARTUNGSANLEITUNG/...
-
Page 3: Table Of Contents
QUASAR GOVERNOR’S GENERAL DIMENSIONS ................... 9 _________________________________________________________ Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/... -
Page 4: General Instructions
(e.g. nominal speed or rope type). c) To adjust any component of the overspeed governor, except for those parts specified in the manual. DYNATECH DYNAMICS & TECHNOLOGY, SL will not be liable for any damage caused by failure to observe any of these general conditions. -
Page 5: Working Principles
The ends of the rope (2) are fastened to the governor’s attachment (1) of the driving bar by using thimbles and cable clips. Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer area in Dynatech’s website in order to consult the full manual; http://customers.dynatech-elevation.com/... - Page 6 Should the rope become untightened or break, there is a de-tensioning contact that would interrupt the safety line in any of the cases. NB. The Quasar governor uses special ropes. Carefully read the Compact tensioning pulley 126 manuals for their proper installation.
- Page 7 The figure displays both the device and its location within the unit (1) TEST PULLEY As an option, the Quasar governor may be supplied with a test pulley. The figure on the right displays its location at the rear of the main pulley.
- Page 8 This governor is DOWNWARDS ACTING ONLY and the performance speed range is: 0.30 – 0.70 m/s Important Note: Customers asking for a QUASAR LS, may know that it´s unidirectional. In order to know the right way, it must pay attention to the arrow in the governor.
-
Page 9: Fixing To The Slab
The anti-creep system requires the lift controller to be able to manage the functions that the anti-creep system uses, such as the coil power, control sensor monitoring and manual rescue. If the controller is unable to manage these functions, Dynatech offers the possibility of installing an electronic module, D-Box. For more information, see the website. -
Page 10: Instructions For Use And Maintenance
(the Dynatech D-Box makes 7 attempts before the error message appears that no reading for the control sensor is detected). -
Page 11: Technical Features
On the other hand, Dynatech governors have anti-corrosion protection in all the cases; however, it is important that maintenance checks if there is a corrosion process that may affect any mobile part of the component and may prevent its natural movement. -
Page 12: Quasar Governor's General Dimensions
INSTRUCTIONS: QUASAR Cod: DYN 48.1.07 Fecha: 04/12/2017 Revisión: 07 Dynatech cannot be held responsible for any problem or accident arising from the non-compliance of the orders and recommendations mentioned both in these instructions and in the documents concerning the EC type examination certificates.
Need help?
Do you have a question about the QUASAR and is the answer not in the manual?
Questions and answers