Table of Contents
Advertisement
9.2. SECONDARY air control
Secondary air control is performed by moving horizontally the regulator which is installed above the
door. When the regulator is opened (handle pulled to the right), firewood burns better. The regulator should
be opened as the furnace works, since in this case the glass remains clean.
- closed -
9.3.Exhaust gases control
Our model is equipped with a device that provides option of exhaust gases control. Opening and
closing of the valve which is mounted on chimney wall is showed in the picture below.
- opened -
The furnace needs to be connected to corresponding chimney. Connection has to be possibly short,
straight or slightly curved up. Links must be tight. Honouring National and European rules and local
regulations concerning construction and firefighting rules is mandatory. Please contact your
chimney sweep for more information.
There must be enough inlet combustion air at the installation site. Diameter of flue connecting pipes
has to be at least adjusted to the smoke exhaust diameter (Ø120 mm). The aperture has to be connected to
the wall in order to enable the acceptance of the exhaust pipe.
Prior to installation do check whether your floor fits to the furnace weight; in case of insufficient load
capacity measures for its increase are to be taken.
- key -
- key -
10. INSTALLATION
- opened -
- closed -
Advertisement
Table of Contents
