Peavey EM-100 Operating Manual page 11

Setup:
1.
Press SET, entering into SET CH function, press UP or Down to
increase or decrease the frequency. You can see that the frequencies
are changed per 125KHz on the LCD displaying screen.
2.
Press down the SET to enter the stereo mono mode, press up to be
in stereo mode and press down to be in mono mode.
3.
Press SET continuously to enter GROUP function, press up or down
buttons to increase or decrease the frequencies. At the same time
you can see from the LCD displaying screen the frequencies are
changed in 1.25MHz increments.
Once a frequency or group has been selected, transmitter and receiver
will need to be synced. Open battery compartment of the receiver and
hold the receiver in front of transmitter with IR LEDs facing each other.
Press SYNC button on transmitter. Once synced, both displays should
read the same frequency, the RF meter on the receiver display should
be registering, and the RF LED on receiver top should be illuminated.
4.
Press SET button continuously to enter RF PWR function, press up
or down to choose the RF power, press UP to set high power 100mW,
press DOWN to set low power 10mW.
5.
Press SET button continuously to enter AF IN function, press up to
increase AF input, down to choose AF IN level: The max input level is
determined by the value selected.
6.
Press SET button continuously to EXIT function. (Please note when
the operation is not continuously used within 8 seconds it will save
the last operation and exit the setup mode.)
7.
When monitoring the audio signal with headphones, plug the
stereo headphones into the headphone output jack (1). The
headphone jack must be stereo 1/4". Rotate the volume (2) to adjust
the proper monitoring volume.
Note: In order to protect your ears, the volume must be adjusted
properly, excessive volume settings may cause damage to ears as
well as a distorted output signal.)
9P06-0100-0125-00
EM-100N2.indd 10
148x210mm 80g书纸黑白印刷!
10
- -
2014/2/19 08:49:50