Tachometer; Odometer, Two Trip Meters And Meter Light Control Display - Toyota Coaster 2015 Owner's Manual

Tachometer

Economy zone
The tachometer indicates engine speed
in thousands of rpm (revolutions per
minute). Use it while driving to select
correct shift points and to prevent en-
gine lugging and over−revving.
For better fuel economy, keep the needle
within the economy zone. Driving with the
engine running too fast causes excessive
engine wear and poor fuel economy.
NOTICE
Do not let the indicator needle get
into the red zone. This may cause
severe engine damage.
Odometer, two trip meters
and meter light control
display
Red zone
The display contains the odometer, two
trip meters and meter brightness indica-
tor that appears when the tail lights/
headlights are on. You can adjust the
brightness when displayed.
The engine switch must be in the "ON"
position.
To change the meter display, quickly push
and release the knob. The meter display
changes in the order from the odometer
to trip meter A to trip meter B to meter
light control (when tail lights/headlights are
turned on), then back to the odometer
each time you push it.
1. Odometer: It shows the total distance
the vehicle has been driven.
2. Two trip meters: They show two differ-
ent distances independently
since the last time each trip meter was
set to zero.
You can use one trip meter to calculate
the fuel economy and the other to
measure the distance on each trip. All
trip meter data is cancelled if the elec-
trical power source is disconnected.
To reset trip meter A to zero, display
the meter A reading, then push and
hold the knob until the meter is set to
zero. The same process can be applied
for resetting trip meter B.
driven
41