BBK 1777 Installation Instructions

27427 BOSTIK COURT
TEMECULA, CA 92590

INSTALLATION INSTRUCTIONS

INS241
201 1-2016 DODGE SRT8
CHALLENGER/CHARGER/300C 6.4L V8
COLD AIR INDUCTION
Part # 1777
Special Tools required:
No special tools required
Install Time: 30 minutes.
Difficulty: Very easy.
!
Note! The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector can see it
when the vehicle is required to be tested for emissions. California requires testing every two years, other states may vary.
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
For any questions, email us:
tech@bbkperformance.com
MADE IN U.S.A. MADE IN U.S.A.
UPDATED LAST: September2017
W W W . B B K P E R F O R M A N C E . C O M
INCLUDED IN THIS KIT
(1) Air filter
(1) Blue rubber coupler
(1) Inlet tube
(1) small rubber grommet
(1) Air shield
Foam edge trim
Vacuum hose
(1) Vacuum hose adapter
Instructions / BBK sticker
(3) Hose clamps
Small edge rubber trim