27427 BOSTIK COURT
TEMECULA, CA 92590
INSTALLATION INSTRUCTIONS
INS235
2009-2017 DODGE CHARGER/CHALLENGER 5.7L (1 3/4")
TUNED LENGTH
EXHAUST HEADERS
Part # 4028 and 40280
Special Tools required: WD-40, 10mm,
13mm, 15mm, 16mm, 18mm sockets
and wrenches, 3/8 ratchet, extensions,
floor-jack and jack stands.
Install Time: 4 to 6 hours.
Difficulty: Average.
!
NOTE! Be sure to work safe! Whenever you work under the vehicle be sure that it is located on level, solid ground
and is supported by adequate safety stands! Remember: Hot asphalt will not support most jack stands!
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
For any questions, email us:
tech@bbkperformance.com
MADE IN U.S.A.
MADE IN U.S.A.
UPDATED LAST: September2017
W W W . B B K P E R F O R M A N C E . C O M
INCLUDED IN THIS KIT
(1) Driver side gasket
(1) Passenger side gasket
(17) 8mm bolts
(4) 10mm studs
(4)10mm nut
(4) flat washer
(4) lock washer
(1) 3/4 long spacer(dipstick)
Need help?
Do you have a question about the 4028 and is the answer not in the manual?
Questions and answers