Proxicast PocketPORT Quick Start Manual

CDMA / EV-DO
• Insert the USB modem into a PC and use the
software on the modem or the CD to activate it and
make a successful connection to your cellular
service provider.
This step is REQUIRED !
• Configure your Ethernet device to automatically
receive an IP address (DHCP)
• Connect your Ethernet device to the PocketPORT
• Insert the USB modem into the PocketPORT
• Power on the PocketPORT
• Wait 30-60 sec. for the Status LED to flash rapidly
Note: Some cellular service providers operate both CDMA and GSM
networks. Check your specific USB modem's capabilities.
PocketPORT

Quick Start Guide

Bridge / IP Pass-Thru Mode

• Obtain an activated SIM, the APN, Username, and
• Insert USB modem into the PocketPORT
• Power on the PocketPORT & wait for Status LED to flash
• Press Reset button for 2 sec. (Status LED = solid red)
• Set your PC to obtain an IP address automatically (DHCP)
• Connect an Ethernet cable between PC & PocketPORT
• Open PC's web browser to:
• Select GSM/HSPA/LTE as the Modem Type and enter
• Click Generate Configuration, then Write Configuration
• Configure your Ethernet device to obtain an IP address
•
Your Ethernet device is now on the Internet !
TM
Password for your account from your cellular provider
Username = admin Password =
your APN, Username and Password
automatically and connect the device to the PocketPORT
Wait 30-60 sec. for the Status LED to flash rapidly
GSM / HSPA / LTE
http://192.168.1.1:8080
1234