Fabtech FTS92011 Instructions

THIS SUSPENSION SYSTEM MUST BE INSTALLED WITH FABTECH SHOCK ASBORBERS
VEHICLES THAT WILL RECEIVE OVERSIZED TIRES SHOULD CHECK BALL JOINTS, TIE RODS ENDS AND
IDLER ARM EVERY 2500-5000 MILES FOR WEAR AND REPLACE AS NEEDED
PRIOR TO THE INSTALLATION OF THIS SUSPENSION SYSTEM A FRONT END ALIGNMENT MUST BE
PERFORMED AND RECORDED. DO NOT INSTALL THIS SYSTEM IF THE VEHICLE ALIGNMENT IS NOT
WITHIN FACTORY SPECIFICATIONS. CHECK FOR FRAME AND SUSPENSION DAMAGE PRIOR TO
INSTALLATION.
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION.
FABTECH RECOMMENDS THAT YOU EXERCISE EXTREME CAUTION WHEN WORKING WITH COIL
SPRINGS TO AVOID ANY POSSIBILITY OF INJURY.
2005 - 2007 FORD F250 / F350 2wd
& 4wd Super Duty Pitman Arm
FTS92011 05-06 Super Duty Pitman Arm
Qua Part # Description
1 FT30122 Pitman Arm
1 FT30206 Pitman Arm Spacer (2wd only)
1 FTLOCK Thread Locking Compound
2 FT92011i Instructions
1 FT30258 Sector Shaft Nut
READ BELOW BEFORE INSTALLING THIS KIT
FTS92011