Page 3 - Pad Setup; Panic; Backup - Nektar Panorama T4 User Manual

Global Settings
Control Function
E1 Keyboard Velocity
Curve
E2 Pad Curve
E3 Aftertouch Delay
E4
Encoder Curve
E5 Expression Pedal
E6 Contrast
E7 Inverse
E8 MapLink

Page 3 - Pad Setup

The Pad Setup page allows you to use the 8 encoders to adjust the trigger threshold independently for each of the 8 pads (default: 40).
If you hold [Shift] while adjusting, you change the setting for all pads simultaneously. The lower the value, the easier the pads will trigger.
Be aware that too low a setting can result in crosstalk and false triggering of pads. Make sure to test your setting changes thoroughly.
If a pad's LED is illuminated red continuously or it triggers when other pads are played, raise the threshold for the respective pad until the
undesired behavior stops.

Panic

Pressing this button sends out the all–notes–off message plus reset all control MIDI messages, on all 16 MIDI channels.

Backup

The Backup function can back up your current controller assignment settings, the 10 user presets and 8 pad maps by sending out MIDI
sysex data. The data can be recorded in your DAW or any other application capable of recording sysex data and sent back to your T4/T6
keyboard when you want to reload your settings.
First start recording in your DAW or MIDI data capture app. Then press the display button labeled [Backup] to start data transmission.
Restoring a backup: A memory dump/backup MIDI sysex file can be sent to the Panorama T4/T6 at any time, while the unit is powered
on. Make sure the Panorama T4/T6 is the output destination of the MIDI track containing the backup data. Once the data transmission has
been completed, the backup has been restored.
www.nektartech.com
Options
Soft 2, Soft 1, Standard, Hard 1,
Hard 2, Fixed
Linear, Soft, Standard, Hard,
Fixed
0-255
Linear Step, Slow, Standard, Fast Adjusts the sensitivity of the encoders.
TYPE 1 (default), TYPE2
20 - 40 (default: 30)
On/Off (default: off)
On/Off
Description
The Soft 1+2 curves emphasize the lower velocity values. Standard is
the default and Hard 1+2 makes it easier to reach the higher velocity
values. If you select Fixed, the default velocity value is 127, but you
can program a control such as a fader or encoder to set the value
dynamically in Internal mode.
The Soft curve emphasizes the lower velocity values. Standard is the
default and Hard makes it easier to reach the higher velocity values.
If you select Fixed, the default velocity value is 127, but you can pro-
gram a control such as a fader or encoder to set the value dynamically
in Internal mode.
Lets you adjust how quickly the Aftertouch sets in.
Allows to cater for different types of expression pedals.
Sets the white/dark balance of the display.
Activating inverse makes white pixels dark and dark pixels white.
When Maplink is on, Pad Maps 1-8 will load with Presets 1-8. Loading
presets 9 and 10 will load Pad Maps 1 and 2 respectively.
Nektar Panorama T4 & T6 User Guide 11