Step-by-step installation
STEP 1 Select a location
Location requirements:
Solid, level surface without carpeting or flooring that may obstruct ventilation
•
Away from direct sunlight
•
•
Adequate room for ventilation and wiring
•
The ambient temperature is always higher than the freezing point (0 ˚C)
•
Away from a heat source
Assembling the rat protection panel (applicable models only)
Tilt the washer a little, insert the shutter and finally fix the shutter with screw to the base as
shown in the picture.
Rear Side
WA4000MK-03843A-00_EN.indd 13
1. Insert the rat protection panel to the
assembling hole on back side to the end.
2. If you have difficulty inserting the panel
lift up the washer a little and insert it.
English 13
4/13/2017 11:02:06 AM