DT Research GC500 Basic Operation Manual

Charging cabinet

GC500 Charging Cabinet

BASIC OPERATION GUIDE

INTRODUCTION

The GC500 Charging Cabinet (ACC-500-311/ ACC-500-315) provides eﬃcient

charging for up to five (5) of the DT311 and DT315 series Mobile Tablets. The

Cabinet has an internal fan for system cooling, and the basic package includes one

charging cabinet and one power cord. With the simple locking connection for the

DT311 and DT315 tablets, the GC500 Charging Cabinet provides convenient tablet

charging and storage with a single wall plug solution.

To charge a DT Research Tablet

(DT311 or DT315 series), open the front door

and pull one of the system trays out from the

Cabinet. Place the Tablet in the tray with the

tablet facing up and the bottom of the tablet

facing the back of the cabinet, and then push

the tray back into the Cabinet. The pins on the

bottom of the tablet should line up with the

pins at the back of the cabinet. Repeat this

step for charging up to five (5) tablets.

Several GC500 System Charging Cabinets can be stacked together with a locking

mechanism to fix the systems in place for stability.

* NOTE: Before powering on the GC500 Charging Cabinet, plug the power cord into the

GC500 and insert the other end into a power outlet.

Table of Contents

Do you have a question about the GC500 and is the answer not in the manual?

Page 1 Several GC500 System Charging Cabinets can be stacked together with a locking mechanism to fix the systems in place for stability. * NOTE: Before powering on the GC500 Charging Cabinet, plug the power cord into the GC500 and insert the other end into a power outlet.
Page 2: Package Contents
2. Do not disassemble any portion of the charger and adapter, as this will void any product warranty. 3. Do not use any power adapter other than the one provided with the GC500 Charging Cabinet or acquired from the manufacturer or its partners.