RichardSolo 10000 mAh 2-Port Power Bank Instruction Manual

10000 mAh 2-Port Power Bank
INSTRUCTION MANUAL
Thank you for purchasing the RichardSolo 10000 mAh 2-Port Power Bank. Please read these instructions before operation
and save for future reference.
OUT1 - Built-in micro-USB output cable (5V 1A)
1
OUT2 - USB output port (5V 2.1A)
2
Micro-USB/Lightning 8-pin adapter located behind
3
micro-USB cable (1)
IN - Micro-USB input port (5V 1A)
4
Power button
5
4 LED charge capacity indicators (25%, 50%, 75%, 100%)
6
USB/micro-USB charge cable
7
Charge 10000 2-Port
Power Bank:
Connect USB/micro-USB charge cable (7)
1
to micro-USB IN port (4).
2 Connect/charge via any powered USB port.
Use USB/AC adapter (not included) for faster
results.
3
Four LEDs (6) flash in 25% increments and remain
solid when corresponding capacity is reached.
*Note: LEDs may not provide an accurate reading
while battery is recharging. For optimum performance,
make sure all LEDs have stopped flashing and remain
solid to ensure full charge capacity. Total recharge
time (0% - 100%) = about 13 hours.
No tandem charge — disconnect devices before
recharging Power Bank.
Check remaining
charge capacity:
Tap/release power button (5)
to check remaining power
bank charge capacity:
1 LED flashing = less than
25%; 1 LED solid = about
25%; 2 LEDs = about 50%;
3 LEDs = about 75%; 4 LEDs
= about 75-100%.
(Not shown in diagram)
Charge device using built-in charge cable:
1
2
3
4
Charge device using your own charge cable:
1
2
3
*Note: Power Bank LEDs remain lit while device is charging and show remaining battery capacity.
When device is full, Power Bank continues to safely trickle charge device. When charge cable is
removed, Power Bank shuts off within 10-20 seconds

Specifications:

Capacity: 10000 mAh
Cell Type: Li-polymer battery
Input: DC 5V 1A
Port 1 Output: DC 5V 1A
(built-in micro-USB cable)
Port 2 Output: DC 5V 2.1A
Size: 5.79" x 3.0" x 0.55"
(14.7 x 7.7 x 1.4 cm)
Weight: 10.0 oz. (283.5 g)
1
3
6
2
4 5
Connect attached micro-USB charge cable (1) to any micro-USB device.
For Apple Lightning devices, use included 8-pin connector adapter (3).
Press power button (5) to begin charging. Monitor charge status via screen icon on your device.
To stop charging, remove cable from your device.
Connect USB charge cable included with your own device to 2.1A Output Port (2) on
Power Bank.
Press power button (5) to begin charging. Monitor charge status via screen icon on
your device.
To stop charging, remove cable from your device.
USB Compatibility:
Port 1 (1A): built-in cable for
micro-USB devices + Lightning
adapter for 8-pin Apple devices
Port 2 (2.1A): iPhone/iPod,
smartphones, MP3 players,
iPad/tablets (use your own
cable)

Package Contents:

10000 mAh 2-Port Li-polymer
battery
USB/micro-USB charge cable
Instructions