Advertisement
CTM3: Manual Changing Table
Installation instructions
•
The wall must be of solid construction and load bearing, capable of
supporting 250Kg
•
Safe Working Load of Changing Table. (SWL) :150 kg
•
Select the correct Anchors before installation,
DO NOT ATTEMPT TO INSTALL USING PLASTIC WALL PLUGS AND
WOODSCREWS
•
Please Note: Due to the complexity of different building methods
Astor Bannerman does not supply installation fixings and anchors
•
N.B The Changing table cannot be installed on a Gypframe™
wall with metal studs
Advice for safe Installation
version 3
Advertisement
Table of Contents
Related Manuals for Astor-Bannerman CTM3
Summary of Contents for Astor-Bannerman CTM3
-
Page 1: Installation Instructions
DO NOT ATTEMPT TO INSTALL USING PLASTIC WALL PLUGS AND WOODSCREWS • Please Note: Due to the complexity of different building methods Astor Bannerman does not supply installation fixings and anchors • N.B The Changing table cannot be installed on a Gypframe™ wall with metal studs... - Page 2 CTM3 Change Table Installation Position Stud Walls with wood supports Noggins. For partition walls, reinforce with 2off noggins made from two pieces of 4" x 2" placed back to back, screwed (not Nailed) in place N.B picture shows optional guard rail...
- Page 3 CTM3 Change Table Advised installation position Bolts are 8mm Diameter Coach Screw (75mm long.) Through Anchor Rawl Bolt (shield anchor) To release the bed pull the black knob outwards...
- Page 4 Gap 40mm Min Distance = 1/2 Bed Length -295mm Hole Centres = 595mm 1262mm Recommended 1162mm Minimum Hole Centres = 797mm Installation process. 1. Unpack the unit. 2. Determine the position of the unit on the wall ensuring that the lower mounting fixing points are at least 438mm from the floor.
Need help?
Do you have a question about the CTM3 and is the answer not in the manual?
Questions and answers