Active Care Medical Wildcat Quick Start Manual

Please Read
Before Operating!
Your ActiveCare product is packaged with a packet of tools
you will need for initial setup. Please locate this packet first.
6. 7.
Assemble the
footrest on the wheelchair above the footrest.
and lock it by latch.
1. 2.
Press the
seat tubes down folding mechanism can
with both hands fold the backrest.
and make sure the
crossbar tubes are
tight and locked.
8.
Fix the heel loop
controller: left motor connector to the left motor,
right motor connector to the right motor, power
connector to battery connector. Each connector is
labeled with the correct connection to make.
Quick Start Guide
Wildcat/Wildcat 450 Power Wheelchair
3.
The backrest Attach the Velcro
strip on the bottom of
the backrest to the
Velcro strip on the
underside of the seat
cushion.
Connect the three main cables to the
4. 5.
Place the two Connect the two
batteries into the frame batteries together using
under the seat. the red battery
connectors.
9.
Ensure that the freewheel mode levers near
the rear wheels are set in "Drive" mode, as
pictured.