Hisense RS-17DR1SS User's Operation Manual page 6

Reversing the Door
The side at which the door opens can
b e changed from the right side (as
supplied) to the left side, if the
installation site requires.
Tools you will need
1. 8 mm (0.315 inch) socket driver
C
2. Cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
8
1. Remove the upper hinge cap (1 ).
2. Using a sharp object, pry out the
plug buttons (5).
3. Remove the two Phillips screws (2)
that connect the upper hinge (3) on
the right side of the cabinet top.
4. Carefully lift the door and place it on
a padded surface to prevent it from
scratching.
5. Remove the plug (9) and transfer it
to the uncovered hole at the right
side. Be sure to press the button
firmly into the hole. Remove the two
bolts (7) that hold the lower hinge (4)
on the right side.
6. Remove the screw-type leveling
front leg (8) and transfer it to the
right side as shown in the figure
below.
7. Set the door into its new place
making sure the pin enters the
bushing at the lower frame section
(hole).
8. Secure the upper hinge (3)
previously removed in step 3 on the
left side. Make sure the pin enters
the bushing at the upper frame
section (hole).
9. Loosely secure the lower left hinge
(4) and do not tighten the bolts until
the door is in the closed position and
leveled.
10. Insert the plug buttons (5) on the
uncovered holes (right side).
11. Replace the upper hinge cap (1 ).
5