Sony SRS-XB31 Help Manual page 17

Perform the pairing procedure on the BLUETOOTH device to detect the speaker.
3
When a list of detected devices appears on the display of the BLUETOOTH device, select "SRS-XB31."
*2
If a passkey is required on the display of the BLUETOOTH device, enter "0000."
*2 The passkey may also be called a "passcode," "PIN code," "PIN number" or "password."
Make the BLUETOOTH connection from the BLUETOOTH device.
4
When the BLUETOOTH connection is established, the
steady state.
If the BLUETOOTH connection is not established, repeat from step
Hint
Once the BLUETOOTH function is activated on the BLUETOOTH device which has been connected to the speaker via a
BLUETOOTH connection, the BLUETOOTH device is connected to the speaker again by just pressing the
PAIRING button.
For details on operating a BLUETOOTH device, refer to the operating instructions supplied with the BLUETOOTH device.
Note
The pairing mode of the speaker is released after about 5 minutes and the
when pairing information is not stored in the speaker, such as at the factory settings, the pairing mode is not released. If the
pairing mode is released before finishing the process, repeat from step
The passkey of this speaker is "0000." If a passkey besides "0000" is set on the BLUETOOTH device, pairing cannot be done
with the speaker.
Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The speaker is already paired with 8 devices and another device is to be paired.
The speaker can be paired with up to 8 devices. If a new device is paired after 8 devices have already been paired, the device
that was paired earliest is replaced by the new one.
The pairing information of the speaker has been deleted from the BLUETOOTH device.
The speaker is initialized.
All pairing information will be deleted. If you initialize the speaker, it may not be able to connect your iPhone/iPod touch or
computer. In this case, erase the pairing information of the speaker on your iPhone/iPod touch or computer, and then perform
the pairing procedure again.
The speaker can be paired with multiple devices, but can only play music from one paired device at a time.
When an audio cable is connected to the speaker's AUDIO IN jack while the speaker and the BLUETOOTH device have been
connected via BLUETOOTH connection, sound from the BLUETOOTH-connected device is not output from the speaker (the
hands-free function is available). To listen to music from the BLUETOOTH device, disconnect the audio cable from the speaker's
AUDIO IN jack.
(BLUETOOTH) indicator switches from flashing to a
.
(BLUETOOTH) indicator flashes slowly. However,
.
17
(power) button/