Eibach 2021.312 Installation Instructions

Installation Instructions

Eibach Springs, Inc.  264 Mariah Circle  Corona, California 92879-1751  USA  Tech Support 800-222-8811 Ext 114
ANTI-ROLL KIT-
BMW 318i, 318is, E36, 4cyl., Exc. Cabrio & Compact 12/90><4/99
BMW 318i, Cabrio, E36, 4cyl., 2/94><4/99
BMW 325i, 2 & 4-door, E36, 6cyl., Exc. Cabrio 12/90><5/92
BMW 325i, 328i, 2 & 4-door, E36, 6cyl., Exc. Cabrio 6/92><4/99
BMW 325i, 328i, Cabrio, E36, 6cyl., 5/93><4/99

Kit Contents

REAR BAR
DOCUMENTS
You have just purchased an ultra-high performance sway bar kit equipped with
high performance poly-urethane bushings – which may cause some additional
road noise and/or bushing noise- this is considered normal.

Preparing the vehicle for Anti-Roll Kit Installation

1. A technician, certified in the suspension work and/or familiar with your particular vehicle, should
perform the Installation of this kit. A factory shop manual may be necessary for the installation of
this kit.
2. Verify the individual Anti-Roll Bars and necessary hardware included in the Eibach Anti-Roll Kit is
correct for your vehicle. Use the Bill of Materials Listing above to verify all hardware. If your vehicle
did not come factory equipped with a rear anti-roll bar, you will need to purchases the "clip nuts" from
a local dealer to secure the rear bar to the lower control arms.
3. Raise the vehicle securely off the ground using a commercial car lift or jack stands.
4. Never work on/or under a vehicle that is solely supported only by a "JACK"!!
5. If necessary, remove the wheels from the axles for better access.

Rear Bar Installation

Removing the factory Rear Anti-Roll Bar

1. Loosen and remove the stock middle bushing brackets (both sides). Do not discard these
brackets, as they will be needed to re-install the Eibach Anti-Roll Bar.
2. Loosen and remove the end links from the anti-roll bar arms (both sides).
3. Loosen and remove the end links from the lower control arm. Do not discard these nuts and
bolts, as they will be needed to re-install the Eibach Anti-Roll Bar.
4. Remove the stock anti-roll bar.
D2606Rev1
#2021.312
Description Part Number
Rear Bar 2021.320HA
Hardware kit
Bushing 2021.3100
Tie Rod 2021.3101
Bolt H13024745
Washer H50025100
Lock Nut H63074700
Lubricant AR.LUBRICANT
Instructions 2021.321INST
Information Kit EPAK
www.eibach.com
Qty
1
2
2
2
4
2
1
1
1
Page 1 of 2