Advertisement
1
ZyXel 3415
Locate Your
Gateway
Ensure that your Apex
Gateway (Zyxel 3415) is set
up and your Wi-Fi is active. If
you are using Fioptics Internet
today, this is likely complete.
If you are installing new
Fioptics Internet service as
well, follow the instructions
with your Apex gateway before
proceeding.
2
Connect the TV
Take your Atom DVR set-top box and place
it close to your TV. Allow at least 7 feet
between Atom and your Apex gateway to
ensure the best quality.
Connect your Atom DVR set-top box to your
TV using either an HDMI or A/V cable.
Plug the power adapter into an outlet. Your
set-top box will begin to power up.
Power on your TV, then select input / source
button using your TV remote. You will see
the Network Setup screen, and can proceed
to step 3.
DIGITAL
LAN
POWER
AUDIO
WPS
A/V OUT
HDMI
USB
RESET
Connect using HDMI cable
Connect using A/V cable
or
3
Network Setup
Now, locate your Fioptics remote and proceed to step
set-top box.
Select connection type
Wired (Ethernet)
Wireless (Wi-Fi)
WPS
WPS
Apex Gateway
(Zyxel 3415)
Now, using your remote, select "Start WPS"
B
on your TV screen.
ETHERNET
WAN
Return to your TV and wait for wireless connection, which can take a few minutes. Once connected,
you will see "Connection successful" on your TV screen. Select "Finish" by pressing OK button on your
Fioptics remote. Next, your set-top box will go through a firmware update. Do not press any buttons
during this update. Once update is complete, your set-top box will reboot and your Fioptics TV service
is now active.
You will still need to program your Fioptics remote to your TV. To do so, please follow the instructions
included with your Fioptics remote.
4
DIGITAL
LAN
POWER
Use these same instructions to connect the remainder of your set-top boxes to the other TVs in
AUDIO
WPS
A/V OUT
HDMI
USB
RESET
your home, following steps 2 and 3.
Network Setup
Exit
Network Status
WPS
Apex Gateway
(Zyxel 3415)
WPS
WPS
WPS
to program this remote to your
"A"
To program your Fioptics remote to your set-top
A
box, press
then hold SETUP button and
at the same time until
blinks twice. Then, using
your remote, from the Network Setup screen,
choose the connection type "Wireless Wi-Fi" by
pressing OK button.
Network Setup
Initiate wireless connection setup
Start WPS
Back
Available Networks
Go to your Apex Gateway, press and hold the
C
WPS button for 3 seconds until it flashes
orange.
button
Advertisement
