Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for RTI EBOT MAZE
Summary of Contents for RTI EBOT MAZE
- Page 1 RM-433 Operation & Installation Guide v1.0 RM-433 Receiver Module DATA...
- Page 2 The RM-433 contains a microprocessor that monitors all received signals so that RF noise and data from non-RTI transmitters is filtered out. When valid RTI data is detected, the RM-433 passes the signal through its output driver which allows the data to travel long distances over wire.
-
Page 3: Product Contents
Output signal is compatible with industry standard infrared repeating systems. This allows multiple IR and/or RF receivers to be wired together into an RTI control system. No dedicated power supply required. Power is derived directly from the RTI control system. -
Page 4: Operation
Operation The RM-433 is designed to operate with an RTI universal system controller and central control system. It receives RF data that was transmitted by the universal system controller, converts it to an electrical signal, and transfers it to the central control system using 3-conductor wire. -
Page 5: Connector Reference
Connector Reference RM-433 Receiver Module DATA +12VDC: Positive power supply connection. Connect to +12VDC on RTI control system. GND: Common ground connection. Connect to GROUND on RTI control system. SIGNAL: Data output connection. Connect to SIGNAL IN on RTI control system. -
Page 6: Installation
Installation The RM-433 can be mounted on a shelf, wall, or cabinet. See below for recommended positioning. For the best reception connect two or more RM-433 units together. This will help eliminate RF reception drop-out due to multi-path interference. Up to ten RM-433 units can be connected together as long as the total wire length does not exceed 1000 ft. -
Page 7: Mounting Hole Pattern
Mounting Hole Pattern 3.0 in. (76mm) RM-433 Receiver Module DATA... -
Page 8: Troubleshooting
Make sure the RM-433 is wired correctly to the central control system, and verify the control system is powered-up. • Make sure the RTI universal system controller is programmed to output RF data. The Data LED turns green when it receives a command, but the control system does not respond •... -
Page 9: Specifications
Specifications Power Requirements: +9VDC to +16VDC @ 60mA RF Carrier Frequency: 433.92 MhZ Output Drive: 200mA maximum Operating Temperature: +32°F to +122°F (+0°C to +50°C) Operating Humidity: 5% to 95% non-condensing Module Dimensions: 3.5 in. x 3.4 in. x 1.0 in. (89mm x 86mm x 25mm) Antenna Length: 13 in. - Page 10 ® It's Under Control R e m o t e T e c h n o l o g i e s I n c o r p o r a t e d R e m o t e T e c h n o l o g i e s I n c o r p o r a t e d R e m o t e T e c h n o l o g i e s I n c o r p o r a t e d R e m o t e T e c h n o l o g i e s I n c o r p o r a t e d 18681 Lake Drive East...
Need help?
Do you have a question about the EBOT MAZE and is the answer not in the manual?
Questions and answers