RPS Studio RS-RT03K Instructions

1 Year Limited Warranty.
Dot Line Corp. warrants that if the accompanying product proves to be
defective to the original purchaser in material or workmanship within 1
year from the original retail purchase, Dot Line Corp. will, at its option,
either repair or replace same without charge (but no cash refund will be
made).
What you must do to enforce the warranty: You must deliver, mail or
ship the product together with the original bill of sale, to:
Dot Line Corp. 9420 Eton Ave., Chatsworth, CA 91311
Phone 1-800-423-2624 Fax 818-700-9797.
Limitation of Liability and Remedies: This warranty is void if any
defects are caused by abuse, misuse, negligence or unauthorized
repairs. All liability for incidental or consequential damages is specifically
excluded. The company shall have no liability for any damages due to
lost profits, loss of use or anticipated benefits, or other incidental,
consequential, special or punitive damages arising from the use of, or
inability to use, this product, whether arising out of contract, negligence,
tort, or under any warranty, even if the company has been advised of the
possibility of such damages. The Company's liability for damages in no
event shall exceed the amount paid for the product. The Company
neither assumes nor authorizes anyone to assume for it any other
liabilities.
Some states do not allow for the exclusion of incidental or consequential
damages, so the above exclusion may not apply to you. This warranty
gives you specific legal rights and you may have other rights which vary
from state to state.
These Instructions are for RS-RT03 Series Wireless Flash Triggers.
Specifications are subject to change. Printed June 2007.
RPS Studio Products are Marketed exclusively by:
Dot Line Corp. 9420 Eton Ave.
Chatsworth, CA 91311
818-700-9997 • Fax 818-700-9797
www.dotlinecorp.com
Product Made in China © Dot Line Corp. 2007
RS-RT03K
Single Channel
Wireless Flash Trigger
Instructions
Features:
This device allows an electronic flash unit to be triggered
from the camera up to 85 ft. away without the use of a
synch cord. The transmitter can be triggered manually or
by the camera, either using the hot shoe or a PC cord.
These instructions cover both the single channel
(RS-RT03K) and 4 channel (RS-RT03K4C) models.
Included in the Package:
1) Transmitter
(with battery installed)
1) Receiver
(2 "AAA" batteries not included)
1) Auxiliary PC Cord
1) Mono Plug to Miniplug Adapter

Installing the Batteries

• The battery is already installed in
the transmitter. To replace the
battery, use a small phillips head
screwdriver to remove the retaining
screw and separate the top and
bottom covers. Replace with a 23A
12V battery. The Negative (-) contact goes against the
spring terminal. Replace the cover and gently screw back
together. Do not overtighten.
• The receiver uses 2 "AAA" batteries
(not included). To Install the batteries,
push aside the end cap on the receiver
and insert the batteries as per the
diagram on the side of the unit.
RS-RT03K4C
4 Channel
Transmitter Receiver
Uses 23A Battery
Slide to Open