Advertisement
1. Make sure your CPU cooler is firmly installed before turning on your system.
2. Check the information in PC Health Status of H/W Monitor in BIOS for the
temperature.
3. Do not touch the CPU socket pins to avoid damage.
4. Whenever CPU is not installed, always protect your CPU socket pins with the
plastic cap covered to avoid damage.
5. Please note that the mating/unmating durability of the CPU is 20 cycles.
Therefore, we suggest you do not plug/unplug the CPU too often.
Memory
The mainboard provides two 184-pin unbuffered DDR333 / DDR400 DDR SDRAM,
and supports the memory size up to 2GB. To operate properly, at least one DIMM
module must be installed.
Install at least one DIMM module on the slots. Memory modules can be installed on
the slots in any order. You can install either single- or double-sided modules to
meet your own needs.
Installing DDR Modules
1. The DDR DIMM has only one notch on the center of module. The module will
only fit in the right orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in
until the golden finger on the memory module is deeply inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.
Power Supply
The mainboard supports ATX power supply for the power system. Before inserting
the power supply connector, always make sure that all components are installed
properly to ensure that no damage will be caused. A 300W or above power supply
is suggested.
ATX 24-Pin Power Connector: CONN1
This connector allows you to connect an ATX 24-pin power supply. To connect the
ATX 24-pin power supply, make sure the plug of thpower supply is inserted in the
proper orientation and the pins are aligned. Then push down the power supply
Advertisement
