Mounting; Pairing Of Sender And Receiver; Warranty; Specifications - ADURO DraftOptimizer User Manual And Installation Manual

3.4 Mounting

NOTE: If mounting at a later time, the 24 Volt plug must not be connected to the ceiling box when
mounting the receiver part in the ceiling box.
The lid on the black ceiling box is "clicked" off by using a screwdriver (picture 1). The wires from the
receiver lid has to be connected to the Terminal at the ceiling box (picture 2).
The lid is "clicked" on and the 24 Volt plug is placed in the ceiling box. The LED's light is red with a
green flash once every second, is a sign that the unit works correctly.

3.5 Pairing of sender and receiver

Hold the sender unit in the hand and activate the pairing by pushing the switch in the middle of the lid.
If necessary, use a pen for it. The LED's light remains red, but it will flash green three times per
second for 30 seconds.
The pairing with the sender happens by pushing the Start / Boost button within 30 seconds.
When it's paired, the DraftOptimizer starts by "boosting", and the LED's light remains red with a green
flash once every second.
The sender and the receiver are now paired and the DraftOptimizer is ready to use.
Notice: The sender's reach is up to 70 metres. Walls, metal screens, radio signals etc. can reduce or
disrupt the reach of the sender.

3.6 Warranty

There is a 2 years' warranty if manufacturing or construction defects occur.

3.7 Specifications

Model
Sender
Battery
Reach
Picture 1
Aduro DraftOptimizer BC/RC
433 MHz
3.6 VDC
Up to 70 m.
Picture 2
6