Nortech AUTOLITH IEHL Quick Reference And Information Manual

AUTOLITH
The
Quick Reference and Information Guide
Align the green lines to connect

The Endoscope and EHL Probe

The doctor should now prepare to fragment the stone. Careful insertion of the EHL probe into the
appropriate endoscope working channel is now accomplished and treatment of the stone is ready
to start. Using direct visualization, the EHL probe tip and the stone are sighted.
physiological SALINE (premixed bags of
times.

Power

Start
effective stone fragmentation.
®
System

Getting STARTED

Turn on the power "ON" switch after plugging the AUTOLITH
proper power outlet. Attach the foot-pedal to the front panel foot-pedal port and
place the sterilized EHL Probe
proper sterile technique.

Connecting the EHL Probe

Connect the EHL probe to the end of the extender cable opposite
the square black ferrite. Pass the remaining end of the extender
cable to the O.R. circulator.

EHL Probe Recognition

The O.R. circulating nurse should then connect the remaining end of the
extender cable to the front panel "PROBE" port. Notice the
Probe" message change to indicate the size of the EHL probe that has
been connected, i.e.
deliver the precise amount of energy specific to the size of the
connected EHL probe.
LOW and increase the power if needed for
The total power range is 10% to 100%
Suggested to start: 30%-40% Power
BiPolar Electro-Hydraulic Lithotripsy
and Extender Cable
1.9Fr. (.63mm). The AUTOLITH
.9% normal saline) should be used for irrigation at all
Indicated for:
Urinary & Biliary
Stones
®
System into a
onto the sterile field using
"Connect
®
System will now
Normal