INSTALLATION INSTRUCTIONS
To properly install this headlight you should have a good understanding of automotive electrical procedures and systems, and
proficiency in the installation of headlights. IF YOU DO NOT, PLEASE SEEK PROFESSIONAL ASSISTANCE.
BEFORE INSTALLATION:
Tools Needed:
3/8" Socket/Wrench (For Mounting)
13mm Socket/Wrench (For Aiming)
Estimated Time:
30 minutes
Wire Functions:
Black = Ground
Red = Front Position
White = High Beam
Orange = Low Beam
Yellow = Turn Signal
Blue =
DRL*
*NOTE: Blue Wire is non-functioning on DOT versions
In the Box:
A. (x2) Mounting Bases
B. (x12) M8-1.25mm Hex Nuts
C. (x8) 1/4"-20x0.75" Hex Head Flange Bolts
D. (x2) Mounting Brackets
E. (x4) M8-1.25"x25 Carriage Bolts
F. (x8) M8-1.25"x25 Hex Head Flange Bolts
G. (x4) M8 Split Lock Washers
A
C
F
D
Input Voltage:
12-24V DC
Operating Voltage:
10-30V DC
B
E
G
B
REGULATORY COMPLIANCE:
PRE-INSTALLATION GUIDELINES:
1. Read all safety notes and mounting guidelines before installing
the product. Verify that all parts listed under "In the Box" are
present and complete.
2. Inspect the product for damage. DO NOT install the product if
there is any damage. Contact the authorized retailer where you
purchased it to initiate a warranty claim if there is damage.
3. Verify that all power supply and/or charging systems comply
to the specified voltage limits for the light.
IMPORTANT NOTES:
J.W. Speaker's Model 9800 is best suited for normal snow
plowing, not "high speed" plowing on highways. Consult with
your J.W. Speaker salesperson for more information.
The Model 9800 is not designed to be a plug and play for Boss
snow plows. If you have a Boss snow plow please see your local
Boss dealer for information on the right product to use.
PRODUCT WARRANTY:
If you have issues with a J.W. Speaker product, please
contact the authorized retailer where you purchased it.
INSTRUCTIONS BEGIN ON THE NEXT PAGE
Model 9800