Keystone KSTAD70C Instruction Manual page 9

Operation
Timer button
Timer
Press to initiate the Auto start and Auto stop feature,
in conjuction with the
When the unit is on, first press the Timer button,
the Timer Off indicator light illuminates. It indicates
the Auto Stop program is initiated. Press it again
the Time On indecator light illuminates.It indicates
the Auto Start is initiated.
When the unit is off, first press the Timer button,
the TIMER ON indicator light illuminates. It indicates
the Auto Start program is initiated. Press it again
the Time Off indecator light illuminates.It indicates
the Auto Stop is initiated.
Press or hold the UP or DOWN button to change the
Auto time by 0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours. The control
will count down the time remaining until start.
The selected time will register in 5 seconds and the
system will automatically revert back to display the
previous humidity setting.
When the Auto start & Auto stop times are set, within
the same program sequence, TIMER ON OFF
indicator lights illuminate identifying both ON and OFF
times are now programmed.
and buttons.
Turning the unit ON or OFF at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/Stop
function.
When LED display window displays the code of P2,
the Auto Start/Stop function will also be cancelled.
Fan button
Fan
Control the fan speed. Press to select either High or
Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set the
fan control to Normal.
Power button
Press to turn the dehumidifier on and off.
Indicator lights
Filter light
Filter
Bucket full light
Full
Continuous dehumidifying light
Cont.
Timer on light
On
Timer off light
Off
High fan light
Turbo
Low fan light
Normal
Auto defrost light
Auto defrost
8