Maintenance - Bauer 1724E-B Owner's Manual & Safety Instructions

Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
tO prEVEnt SEriOuS inJury FrOM tOOL FaiLurE:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFOrE EacH uSE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
installing replacement cable
1. Pull old Cable (1) out of Drum (20) until
connection to Drum Cable (8) is accessible.
2. Remove Cable Screw (2) from Drum Cable.
Separate Cable from Drum Cable.
Page 12 For technical questions, please call 1-888-866-5797.
2. aFtEr uSE, wipe external surfaces of
the tool with clean cloth. Store indoors
out of the reach of children.
3. WarninG! if the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
3. Connect new Cable to Drum Cable using
Cable Screw and feed Cable back into Drum.
Item 64063