Table of Contents
Advertisement
5 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
SyncMaster 33*TFT/53*TFT monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
5-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
5-1-1 Removing the Stand
1. Carefully push the edge of the hinge cap with
a ÔÐÕ screw driver until the opposite end of the
hinge cap releases.
Figure 5-1
2. Remove 4 screws in the hinge area.
Figure 5-2
3. Push the stand to the left side to release the
hinge.
Caution:Be careful. Signal cable and power
cable are still attached to the monitor.
4. Lift the stand away from the monitor until
Vesa Cover is completely visible. And pry it
off the back of the monitor.
SyncMaster 33*TFT/53*TFT
5. Disconnect Power Cord and Signal Cable.
5-1-2 Main Body Disassembly
1. Remove the 4 screws on the Rear Cover.
(Marked:
)
2. Remove Rear Cover from the Front Cover.
3. Remove 6 screws on the Shield.
(Marked:
)
4. Disconnect Inverter wire, Function PCB wire
and Interface wire.
5. Remove the Main PCB Assembly.
Figure 5-3
Figure 5-4
5-1
- Quick Links:
- Product Specifications
Hide quick links:
Advertisement
Table of Contents
