Page 1
QUALITY POWER SOLUTIONS BACKED UP BY REAL-WORLD ENGINEERING EXPERIENCE User’s Manual SR100Hi Series - 100 W DC UPS No-Break DC UPS STANDARD FEATURES OPTIONAL FEATURES Comms: • RS232 • RS485 3 Relay Alarms-Form C • Modbus • SNMP & Webpages Float Charger –Lead Acid Batteries...
SR100Hi Series - 100 W DC UPS 1. SAFETY The user is responsible for ensuring that input and output wiring segregation complies with local standards and that in the use of the equipment, access is confined to operators and service personnel. A low resistance earth connection is essential to ensure safety and additionally, satisfactory EMI suppression (see below).
SR100Hi Series - 100 W DC UPS 2. INTRODUCTION: The SR100Hi power supply is designed to provide DC power to lead acid batteries for critical back up applications. 3. SR100Hi Series - SYSTEM BLOCK DIAGRAM The No-Break ™DC - SR100Hi power supply is designed to provide DC power to lead acid batteries for critical back up appli- cations.
SR100Hi Series - 100 W DC UPS 5. FRONT PANEL LAYOUT 1. AC INPUT IEC60320 - C13 10A 2. 3 DIGITAL INPUT & 1 DIGITAL OUTPUT: I/O terminals are customizable and if used, the product will have a unique code.
SR100Hi Series - 100 W DC UPS 6. CONNECTION AND INITIAL TESTING 1. Check input and output voltages of system, ensure that they match the equipment. All loads should be isolated. 2. Check polarity of all wiring. Place temperature sensor probe near or on batteries.
SR100Hi Series - 100 W DC UPS 8. SR100Hi– DC SETTINGS Actual settings if different from default Parameter Default Settings V nominal V output (20°C) 13.8 27.6 34.5 41.4 55.2 BatDetect (mins) Vpres: 12.2 24.4 30.5 36.6 48.8 Vbatl: 27.5 Vshutd: 11.5...
SR100Hi Series - 100 W DC UPS 9. SR100Hi– CONNECTIONS - Typical Examples • Standard No-Break™DC charger and battery bank This is the basic connection which is most commonly used, and provides adequate protection for the majority of systems requiring DC back up in the event of a mains power failure.
SR100Hi Series - 100 W DC UPS • N+1 connection using two complete No-Break™DC systems with each one capable of supplying the loads- positive common SRxxx Hi L+ B+ INPUT BATT1 ECB/LVD Alarms available Power OK ALARMS LOAD Battery missing...
SR100Hi Series - 100 W DC UPS 11. Technical Specifications Output power 100W Input Voltage 180V - 264VAC 45-65Hz Output Voltages 12V, 24V, 30V, 36V, 48 VDC Voltage Adj. Range 85% - 105% of Vout Overcurrent protection Constant current limit under overload and short circuit conditions Input –...
13. TERMS OF WARRANTY Helios Power Solutions warrants this product for 24 months from date of shipment against material and workmanship defects. Liabil- ity under this warranty is limited to the replacement or repair of the defective product as long as the product has not been damaged through misapplication, negligence, or unauthorized modification or repair.