Problem Solving - Audiovox AXT-2411 User Manual

2.4ghz analog cordless phone
Table of Contents

Advertisement

TROUBLE SHOOTING
Problem Solving Section
For your assistance, we have listed below a few common problems.
Phone does not work, check the following:
1. Base Unit is plugged into a power source.
2. Handset is charged.
3. TONE/PULSE Select Switch is in the right position.
4. Telephone Line Cord is plugged into the Telephone Jack.
Range of phone limited, check the following:
1. Base Unit is centrally located in your residence.
2. Base Unit is not located near appliances.
No dial tone, check the following:
1. Telephone Line Cord plugs are connected to the Telephone Jack and Telephone Line
Connection Jack.
2. Base Unit is plugged into a power source.
3. If you had a power failure or had unplugged the Base Unit, replace the Handset on the
Base Unit for 2 to 5 seconds to reset the system.
Received signal flutters or fades, check the following:
1. Battery Pack in the Handset is fully charged.
2. Handset is not too far from the Base Unit.
Interference on reception, check the following:
1. Noise may be picked up from electrical products in the home or electrical storms.
Generally, this noise is a minor annoyance and should not be interpreted as a defect in
your system.
2. Choose an alternate channel using the
3. Do not use this telephone within 20 ft. of a microwave oven while it is working, as you
may experience interference. This is a normal occurrence with 2.4GHz phones and
should not be interpreted as a defect in the product.
If after pressing the
1. Base Unit is plugged into a power source.
2. If you had a power failure or had unplugged the Base Unit, replace the Handset on the
Base Unit.
NOTE: If none of the telephones in the house are working, disconnect one set at a time to
verify that none of the phones are causing the problem. If you still have a problem after doing
this, and your telephone still does not work, please contact your local phone company.
Channel/Code button on the Handset.
Talk
button, you receive three "beeps" and no dial tone, check the following:
- 27 -

Advertisement

Table of Contents
loading

Table of Contents