The GSM-ANTHB Kit provides external antenna capability for GSM and iGSM communications devices.
NOTE: This antenna is for indoor use only.
This kit consists of an Antenna and Adapter Cable (for connection to the communications device).
To assemble, refer to the figure below and perform the following steps:
NOTE: Refer to the communication device's Installation and Setup Guide for mounting, wiring and
Remove the front cover from the communications device.
Install the through-hole connector of the adapter cable in the top hole on the enclosure back of the
communications device. Secure with lock washer and nut.
Snap the other end of the adapter cable in the external antenna port of the communications device.
Attach the antenna to the connector on top of the enclosure. Replace the front cover.
Installation & Setup Guide
SMA / MMCX
ANTENNA ADAPTER CABLE
FOR EXTERNAL ANTENNA
50 OHM MMCX ONLY
7720P PROGRAMMER PORT
NOT FOR TELEPHONE SERVICE USE!
PRIMARY POWER: 9 - 16.5 VAC
CURRENT: 900mA PEAK, 70mA STANDBY
BATTERY: 8V. 3.1 AHr FOR 24 Hr BACKUP
800-02377 7/08 Rev. A
AND SPACERS (4)