Advertisement
FIGURE 4 DIRECTOR & DIPOLE
ASSEMBLY DETAIL (J55 & J105 SERIES )
Down Lead Connection
Attach down lead and weatherproof connection appropriately.
Final Orientation
Rotate the antenna until maximum signal strength is received, then fully tighten the hex nuts on the "U" bolt
assembly.
Arrays
J-Series 75-ohm antennas may be attached both vertically and horizontally for greater gain and directivity. It
is essential that the spacings given below in Figure 4 and Table 3 be strictly adhered to for best possible
results.
The gamma feeds of all antennas within the array must face in the same direction for proper polarity. Note
that the feeds shown in Figure 4 all face right as viewed from the front of the antenna.
A
2 - BAY
VERTICAL ARRAY
B
A/2
2 - BAY
HORIZONTAL ARRAY
Splitting harnesses may be made from any good quality 75-ohm coaxial cable such as RG-6/U and Jerrold
Model F-659 (pat.pend.) adjustable coaxial connectors, Jerrold Model 1596A two-way or Model 1597 four-
way splitters are recommended. These should be used with Model HB-1 outdoor housings for weather
protection. Instructions for use are supplied with each splitter. Consult your Jerrold dealer. Each leg of the
harness should be as short as and directly routed as practical with no sharp bends, length is not critical.
However, the pairs of input cables for each 1596A splitter or pair of splitters must be of equal length; the
four input cables for Model 1597 splitters must also be of equal length.
B
A
QUAD ARRAY
TWO WAY
FOUR WAY
SYMBOL INDICATES SPLITTERS
LOCK WASHER (Internal Tooth)
FLAT WASHER
MODEL
J55-2
J55-3
3A
J55-4
J55-5
J55-6
J55-FM
J105-7
J105-8
4 - BAY
J105-9
VERTICAL ARRAY
J105-10
J105-11
J105-12
J105-13
DIMENSION A
DIMENSION B
(in inches)
(in inches)
140
208
127
188
116
172
102
150
94
140
80
120
54
74
52
72
50
70
48
67
46
65
45
63
44
61
29 Sharp Rd,
Brantford, Ont., Can., N3T 5L8
www.wadeantenna.com
Advertisement
