Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Neat WALL Family
Summary of Contents for Neat WALL Family
- Page 1 WALL Family Wall mounted I/O unit User manual NE41 12005-02 v2.0...
- Page 2 This device complies with part 15 of the FCC Rules. Operation is NEAT Electronics AB is not responsible for any loss of data, subject to the following two conditions: (1) This device may not income or any consequential damage whatsoever caused.
-
Page 3: Table Of Contents
Contents About WALL Family products The WALL Family consist of 11 prod- About WALL Family products ucts divided into two categories, Product variants WIOR and ROOM categories, each Hardware overview Front overview with a different hardware setup Back overview to accomodate special needs and The screw connector requests. -
Page 4: Product Variants
ROOM+PEAR x 3 6.35 mm tele jack Hardware overview Front overview The front basically consist of a plastic cover with one or three LEDs and a combination of buttons and connec- tors (examples below). WALL Family User manual NE41 12005-02 v2.0... -
Page 5: The Screw Connector
ROOM and ROOM+PEAR The relay outputs acts according to the settings in the builtin actionplan or by a superior system (by radio). WALL Family User manual NE41 12005-02 v2.0... -
Page 6: Jumpers J1 And J2
. If Jumper J1 is mounted the unit must be externally powered. The ports are of type Normally Open IN1 for ROOM and ROOM+PEAR is always normally open. WALL Family User manual NE41 12005-02 v2.0... -
Page 7: Manual Configuration
Tamper OK alarm 2. Remove J2 3. Power on the unit and replace the J2 within 5 seconds from power on. 4. The LED blinks green 3 times. WALL Family User manual NE41 12005-02 v2.0... - Page 8 LED action for relay 1. will blink rapidly for 2 seconds. When this happens the manual configuration is cancelled and it is necessary to restart the procedure. WALL Family User manual NE41 12005-02 v2.0...
-
Page 9: Remove A Transmitter
(NPU) and the software WALL Family • Read instructions prior to use. Programmer. • Always test the system per instructions prior to use. The NPU can be purchased from • This product may not be suitable for all NEAT Electronics and the software persons. can be downloaded from our home- page: www.neat-group.com/se/en WALL Family User manual NE41 12005-02 v2.0... -
Page 10: Disposal
• The product fulfils the requirements of the household waste. It should be deposited at EMC-Directive 2004/108/EC. an appropriate facility to enable recovery • It does not cause electromagnetic distur- and recycling or returned to NEAT bances under normal working conditions. Electronics AB. • The product can be placed near other products or devices as long as mechanical vibration is not present. • Always check the function of the product after making adjustments. • Please remove batteries if the unit is to be out of use or stored for an extended period of time. WALL Family User manual NE41 12005-02 v2.0... -
Page 11: Technical Data
150 ms Jumper change delay Tamper remove/insert delay Radio test alarm + 4 alarms every day (when battery powered) The frequencies for each market is programmed during production and not changeable by the user. WALL Family User manual NE41 12005-02 v2.0... - Page 12 www.neatelectronics.se...
Need help?
Do you have a question about the WALL Family and is the answer not in the manual?
Questions and answers