Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Bradley Manuals
  4. Water System
  5. Terreon Quadra-Fount Washfountain MF2944/TT
  6. Installation instructions manual

Bradley Terreon Quadra-Fount Washfountain MF2944/TT Installation Instructions Manual

Multi-fount series washfountain
Hide thumbs

Advertisement

Quick Links

IMPORTANT
Read through this installation manual to
ensure proper installation.
Make sure that water supply is completely
off before installation is begun.
When drilling into tile, masonry, or other
hard materials to install wall and floor
anchors, be sure to wear safety goggles to
prevent eye injuries.
Wall anchors used must have a minimum
pull-out rating of 1,000 lbs.
The Quadra-Fount® requires a water
flowing pressure of at least 20 psi, but no
greater than 80 psi.
File these instructions with the owner or
maintenance department.
215-1539 Rev. A; EN 03-063
© 2003 Bradley Corporation
Page 1 of 16
12-18-2003
Installation
Instructions
Bradley Multi-Fount™ Series
MF2944/TT
®
Terreon
Quadra-Fount
Washfountain with Touch
Time® Control
(Standard* & Juvenile Height)
*Standard Height is ADA Compliant

Table of Contents

Pre-Installation Information . . . . . . . . . . . . . . . . . . .2
Washfountain Components List . . . . . . . . . . . . . . . .3
Installation Instructions . . . . . . . . . . . . . . . . . . .4-10
Cleaning and Maintenance . . . . . . . . . . . . . . . .11-12
Solenoid Valve Troubleshooting . . . . . . . . . . .13-14
P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY
http://www.bradleycorp.com
®
FAX 262-251-5817

Advertisement

loading
Need help?

Need help?

Do you have a question about the Terreon Quadra-Fount Washfountain MF2944/TT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Bradley Terreon Quadra-Fount Washfountain MF2944/TT

Summary of Contents for Bradley Terreon Quadra-Fount Washfountain MF2944/TT

  • Page 1: Table Of Contents

    20 psi, but no greater than 80 psi. File these instructions with the owner or maintenance department. P.O. Box 309, Menomonee Falls, WI 53052-0309 215-1539 Rev. A; EN 03-063 TEL. 1-800-BRADLEY FAX 262-251-5817 © 2003 Bradley Corporation http://www.bradleycorp.com Page 1 of 16 12-18-2003...

  • Page 2: Pre-Installation Information

    1. This warranty is limited to replacing or repairing, at our option, transportation charges prepaid by the purchaser, any Bradley unit or part thereof which our inspection shall show to have been defective within the limitations of this warranty.

  • Page 3: Washfountain Components List

    • Pipe sealant and plumber’s putty • 110 VAC power source for 110/24 VAC plug-in transformer supplied • OPTIONAL: Bradley recommends installing an electrical cut-off switch to the unit. This feature prevents accidental water delivery during regular maintenance and service.

  • Page 4: Installation Instructions

    1/2 NPT SUPPLIES - 5" FROM WALL STUB OUT MIN. 1-1/2" FROM FLOOR 1-1/2" NPT WASTE CONNECTION FINISHED FLOOR THROUGH FLOOR - 3" FROM WALL * Subtract 4" from this dimension for juvenile height model. Figure 1 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 5 2. Install the upper bracket to the pedestal panels with two pan head 1/4"- 20 x 1/2" screws and 5/16" I.D washers supplied. 3. Install the lower bracket to the pedestal panels with two pan head 1/4"- 20 x 1/2" screws and 5/16" I.D. washers supplied. Figure 2 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 6 (supplied by installer) for 3/8" diameter bolts. 6. After floor anchors are installed, secure the pedestal assembly to the floor anchors using two 3/8" diameter bolts and washers (supplied by installer). Figure 3 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 7 1/4-20 x 1/2" Screws Hot Supply Inlet Stop/Check Valve Solenoid Valve Assembly Cold Supply Inlet Navigator® TMV Braided Hose Figure 4 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 8 Back View of Washfountain Bowl #10-24 x 1/2" Dome Screw for Strainer Strainer Drain Spud Washfountain Bowl Spud Discard this Washer washer; it is not used on Spud washfountains. Locknut Figure 5 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 9 Solenoid Assembly Gray Wires Navigator® Mixing Valve Supply Inlet Brown Wires Green Wires Black Wires Gray Green Black Left Right Right Brown Center Center Button Left Button Button Button Figure 7 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 10 3. To install front panel, slip holes in bottom of front pedestal panel over the two pins on the lower bracket (see Figure 10) 4. Secure panel to upper bracket with attached screw. Figure 10 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...

  • Page 11: Cleaning And Maintenance

    ® Solid Surface cleaner and polish to refresh and protect the Terreon Solid Surface material.Bradley recommends additional care and maintenance for the darker colored Terreon, for complete instructions on this additional maintenance see Bradley document #1505. IMPORTANT: DO NOT USE STRONG ACID OR ALKALINE CHEMICALS AND CLEANSERS TO CLEAN TERREON.
  • Page 12 It is emphasized that all products should be used in strict accordance with package instructions. 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...

  • Page 13: Solenoid Valve Troubleshooting

    • reconnect to the adjacent valve and turn on the water supplies to the unit; • depress the Touch Time pushbutton. If the station still fails to turn on, replace the sensor. 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...
  • Page 14 DIAPHRAGM 269-577 ARMATURE 269-578 SPRING 269-1729 ARMATURE HOUSING 269-1730 CLAMP, ARMATURE HOUSING 269-579 COIL, SOLENOID VALVE 160-447 SCREW, #8 X 5/8 125-001CS O-RING, #2-013 125-160 FLOW RESTRICTOR, .5 GPM Figure 11 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...

  • Page 15: Thermostatic Mixing Valve Troubleshooting

    Problem: Limited water flow Cause: Dirt and debris have built up in the valve or strainer. 1. Remove and clean strainer. If strainer needs to be replaced, order Bradley part no. 173-028. 2. Check the piston for smooth movement. To check the valve's piston for free and smooth movement, follow the procedures outlined below: 1.
  • Page 16 Thermostatic Mixing Valve (S01-520) Repair Kit S65-259 Item Description Nut 3/8-24 Hex Jam Spring Piston Thermostat O-Ring O-Ring O-Ring 173-028 Strainer O-Ring Stem Thermostat Piston Spring Strainer Valve Body Strainer Figure 12 12-18-2003 Bradley Corporation • 215-1539 Rev. A; EN 03-063...