Table of Contents
Advertisement
19
1) Attach insulation TAPE on connector via silk line using
tweezers.
2) Attach GASKET TAPE on insulation TAPE.
1) Press equally TAPE.
22
1) Screw 4 points marked in red circle.
1) Confirm SET's assembly condition and whether there is GAP in
assembly department side.
20
1) Put Main PBA on FRONT.
2) Put MOTOR in FRONT MOTOR HOLE and put WIRELESS LAN, BT ANT
into each FRONT GROOVE.
1) Fix so that there may not be MAIN PBA move.
2) Confirm whether POWER KEY was put properly.
8-5
SAMSUNG Proprietary-Contents may change Without notice
This Document can not be used without Samsung's authorization
Exploded and assembling View
21
①
②
1) Combine from upside → middle → in below sequence.
1) If inflict unreasonable force at work, badness that locker of
upper direction is broken happens.
③
Advertisement
Table of Contents
