TSI Instruments PORTACOUNT PRO Quick Start Manual

PORTACOUNT
This guide will help you to
quickly begin using your
®
PortaCount Pro /Pro+
Respirator Fit Tester for first
time use with a personal
computer.

1. Software Installation

Install the FitPro+™ Fit Test
software on your computer (for
detailed instructions, please see
the FitPro+ Fit Test Software
Users Manual, included on the
FitPro+ Software CD in pdf
format).
2. Initial PortaCount Pro/Pro+ Respirator Fit
Tester Start-Up
Plug the PortaCount Pro fit tester into an AC
power source. Press the On/Off button to
turn the PortaCount Pro fit tester on.
Refer to the Interactive Training Tutorial
other necessary components and procedures, such as
when to install the Alcohol Cartridge and how to perfrom
the Daily Checks.

3. Communications Setup

After the PortaCount Pro fit tester has completed its
initial warm up, connect the USB cable from the
PortaCount Pro fit tester to your computer.
Connect the "USB-A" connection to the computer, the
"USB-B" connection to the PortaCount Pro fit tester.
TSI, TSI logo, and PortaCount are registered trademarks of TSI Incorporated. FitPro/FitPro+ is a
trademark of TSI Incorporated. Microsoft, Windows, and Vista are registered trademarks of Microsoft
Corporation.
®
PRO/PRO+ RESPIRATOR FIT TESTER
QUICK START GUIDE

4. Device Driver Installation

Microsoft
drivers install automatically.
Microsoft Windows XP operating system: Follow the
"Found New Hardware Wizard" to install the device
drivers.
to learn about
If the Wizard does not start automatically, or drivers do
not install as described, refer to the
PortaCount Pro-to-PC Communications
course located at the PortaCount Academy
Training Center

5. FitPro+ Software Start-Up

Start the FitPro Fit Test software.
If prompted, select the appropriate default exercise
protocol that your organization follows for fit testing. For
example: "OSHA 29CFR1910.134". Click Next>>.
® ®
Windows 7 and 8 operating system: Device
website: www.tsi.com/pcacademy.
RESFT 201:
instructional
Online