Download Print this page

Braun Group XTR202-SFP User Manual

100m multi-port media converter

Download this manual

1. 100M Multi-Port Media Converter

1.1. Brief Introduction

Thanks for purchasing Multi-Port 100M optical transceiver! This product

supports IEEE802.3Z/AB 100Base-SX/LX protocol, the working mode of

duplex full mode and half mode. The electric interface is the rate of 10M and

100M as well as the through line and cross wire. This manual is for various

models of optical transceivers.

1.2. Packing list

Please check the following items in the package before installing the

converter.

Media converter

AC/DC adapter (external)

User manual

Please contact the dealer immediately for any missing or damaged items.

1.3. Installation

1 . Interface

RJ-45 interface

The transmission media is CAT5 twisted-pair with a maximum length of 100

meters. It features auto -negotiation of straight through line and crossover

cables.

Fiber interface

The SC or LC fiber interface is of duplex type, namely TX and RX. When

the two sets of optical transceiver are interfaced or connected to switch with

fiber interface, the fiber is in cross connection, namely "TX-RX", "RX-TX"

(direct butting for single optical fiber).

XTR202-SFP

1piece

1copy

Table of Contents

Page 1: Packing List
XTR202-SFP 1. 100M Multi-Port Media Converter 1.1. Brief Introduction Thanks for purchasing Multi-Port 100M optical transceiver! This product supports IEEE802.3Z/AB 100Base-SX/LX protocol, the working mode of duplex full mode and half mode. The electric interface is the rate of 10M and 100M as well as the through line and cross wire.
Page 2: Led Indicators
XTR202-SFP 2 . Connection Connect the network device (work station, hub or switch) to the RJ-45 jack of the optical transceiver through twisted-pair CAT5. Connect the multi- mode /single mode fiber to SC/LC fiber interface of the optical transceiver. Turn the power on. The corresponding LED is on for a correct connection.
Page 3: Main Features
XTR202-SFP 1.5. Main features 1. Conforms to IEEE802.3Z/AB 100 Base-T/SX/LX standard 2. Back pressure flow control for full duplex IEEE802.3 X and half duplex. 3. Automatic identification of MDI/MDI-X cross line. 4. Conforms to safety code of FCC and 15 CLASS A, CE.
Page 4 XTR202-SFP 2. If power loss is excessive in the fiber, please check and clean the fiber patch cord connectors. 4. Responsibility Note (1) The user should cover the damage during transport to equipment resend for maintained at the user’s own expense...