General Information - Novy 780 Fusion+ Operating And Installation Instructions

Table of Contents

Advertisement

Available languages

Available languages

GENERAL INFORMATION

General
These are the mounting instructions for the Novy hood shown on the cover. The manual is a separate booklet that
has been supplied with this hood. Read these instructions carefully before installing and commissioning the hood. It is
recommended to have one or more qualified persons carry out the installation.
Carefully take the hood from the packaging. Check if all mounting materials have been supplied using the drawings on
page 2.
The hood is to be used above a hob and/or domino and intended for household use only.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
• For easier mounting of the telescopic hood it is recommended to do this with at least 2 persons.
• Check if all mounting materials have been supplied using the drawings on page 2.
• Position the wall socket such that it is near the hood.
Exhaust or recirculation
Before starting any mounting activities, you must have made the choice if you are going to make an exhaust duct to the
outside or if you are going to use the hood as a recirculation hood. In case of an exhaust duct to the outside, carefully
read the section in these mounting instructions for installing the exhaust duct. For recirculation, please separately order
the recirculation kit.
INSTALLATION
Follow the mounting drawings on page 2.
PAY ATTENTION TO THE FRONT AND REAR SIDES OF THE COOKER HOOD.
The glass adjustable flap opens forwards. The lighting is installed on the rear. Carefully look at the mounting drawings!
Preparations for mounting:
1
The model 780 is meant for integration into a kitchen cabinet 60 cm wide, the model 786 is for a kitchen cabinet 90
cm wide and the model 787 is for a kitchen cabinet 120 cm wide.
The recommended mounting height for an electrical or ceramic cooking plate is min. 600 mm and max. 750 mm. The
mounting height for a gas or induction cooking plate is min. 650 mm and max. 750 mm.
Mount the brackets:
- Provide a kitchen cabinet without a bottom.
- Mount the 2 supplied mounting brackets against the inner walls of the cabinet using the 8 supplied screws. Make
sure to mount the correct brackets on the left and on the right.
- The bottom of the bracket should be at the same height as the bottom of the cabinet. The tab (x) on the bracket
must be level with the front side of the cabinet.
- If the cabinet has a reinforcement strip, the distance between the front of the cabinet and the bracket must be
23 mm. Attention! First break the tab (x) from the mounting bracket.
Mount the cooker hood:
2
Preferably install the cooker hood with 2 persons.
- Push the cooker hood from the bottom straight up into the kitchen cabinet. Pay attention to the front and rear
sides of the cooker hood.
- Push the hood fully into the cabinet, so the sides of the cooker hood are resting on the mounting bracket. Keep
supporting the cooker hood.
- Remove the fat filters from the cooker hood.
3
- On the left and rights sides there are a total of 4 openings for placing the screws into the mounting bracket. Tigh-
ten the 4 screws, thus fixing the cooker hood onto the mounting brackets.
Slide the backspacer backwards to close the back of the cabinet. You can see the screws for sliding the backspacer
4
on the top of the cooker hood. Slightly unscrew these screws.
EN 9

Advertisement

Table of Contents
loading

This manual is also suitable for:

786 fusion+787 fusion+

Table of Contents