Notice Of Operation; Troubleshooting - Ideal Air DS190 Manual

190 pint
Table of Contents

Advertisement

FOUR
:

NOTICE OF OPERATION

1. There is a 3 minute delay after machine has shut down prior to next start up cycle.
2. The machine will operate between 41°F – 89.6°F.
3. Do not place the unit on ground slopping more than 45 degrees.
4. We suggest wash the filter once per month. Immerse the filter in warm water when cleaning,
lightly brush, install after it air drys.
5. Make sure the machine's air inlet and outlet are 10cm / 4" away from the wall to ensure
proper operation.
6. Completely clean water tank after using to avoid mold growth.
7. Pull out the plug if not using the unit for long periods of time. Coil the power cord on the coil
seat and insert the plug into the plug holder.
8. There is a door at the front of the machine. Press the top of the door, to open it automatically.
Remove the water tube, connect one end with water outlet to the water tank, and the other end
through the water drainage port on left side of machine. Maximum length of the tube is 20'.
When the room temperature is low, unit will run into Auto-Defrost function.
"Accumulative work time" on display means how much time unit have be operated. (This number is
calculated by ten minutes, the first ten minutes latest after power off doesn't calculated in).
FIVE
:
TROUBLE SHOOTING
MALFUNCTIONS
Does not humidify
Dehumidify in low
Random noise
When above malfunctions occur and must be repaired, contact Ideal-Air technical support,
do not disassemble the machine privately.
Hot air blowing from the air outlet is normal.
ANALYSIS
1) Power failure
2) Switch is in off position
3) E4 is illuminated on display panel
1) Filter dirty
2) Blockage in air inlet or outlet
3) Room is not sealed
4) Temperature is low in room
1) Unit is unstable
2) Air outlet clogged
3
SOLUTION
1) Check Circuit breaker
2) Switch is in on position
3) Empty water tank
1) Clean Filter
2) Remove Blockage
3) Close the doors, window and
block any sunlight
4) The dehumidify capacity is
low when room temperature
is low
1) Stabilize unit
2) Clean air filters

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents