Table of Contents
Advertisement
C
leaning and Maintenance
When there is a possibility of freezing ambient temperatures.
• Close the water taps and remove the Water Supply Hose.
• Remove the water which remains in the water supply.
• Lower the drain hose flat against the ground and drain any remaining water left in the bowl the and drain hose.
If frozen
• Remove the water supply hose, and immerse it in Hot water at approx.. 40°C.
• Pour approx.. 2 liters of Hot water at approx.. 40°C, into the bowl and let it stand for 10 minutes.
• Connect the water supply hose to the water tap and confirm that the washing machine performs the
supply and drainage of water.
Wash Inner-tub
Leave the lid open after washing to allow moisture to evaporate. If you want to
clean the inner-tub use a clean soft cloth dampened with liquid Detergent, then
rinse. (Do not use harsh or gritty cleaners.)
Inlet Hoses Exterior It is recommended to replace the inlet hoses to the tap every 5 years. Immediately
wipe off any spills. Wipe with damp cloth. Avoid hitting the machine's surface
with sharp objects.
Do not use stain removal sprays or agents on, near or next to the machine.
Doing so can damage the machines finish and cause corrosion
Long Vacations
Be sure water supply is shut off at the tape. Drain all water from hoses if weather
will be below freezing.
Cleaning the Inside of your Washer
If you use fabric softener or do regular Cold water washing, it is very important that you occasionally clean
the inside of your washer.
• Fill your washer with Hot water.
• Add about two cups of dish washing detergent.
• Let it operate for several minutes.
• Stop the washer, turn off the power without daring the water, then open the lid leave it to soak overnight.
• After soaking, drain the washer by briefly selecting a spin cycle until water has drained, and run it through
a normal warm water cycle without adding any detergent or clothes.
Or use Tub Clean Program periodically.
We do not recommend that you wash clothes during this procedure.
Products that might damage your washing machine
• Concentrated bleaches and diaper sanitizer will cause damage to the paint work and components of
your washer.
• Hydrocarbon solvents i.e. petrol, paint thinners and lacquer thinners, etc. can dissolve plastic and blister
paint (Be careful when washing garments stained with these solvents as they are flammable DO NOT
put them in washer or dryer without presoaking and rinsing them first.)
• Some pretreatment sprays or liquids can damage your washer' s control panel.
• Use of dyes in your washer may cause staining of the plastic components. The dye will not damage the
machine but we suggest you thoroughly clean your washer afterwards. We do not recommend the use
of dye strippers in your washer.
• Do not use your washer lid as a work surface.
33
Advertisement
Table of Contents
